Motorbike & Motorcycle Battery Charger Scooter & moped Battery Charger ATV & Four Wheeler Battery Charger Car Battery Charger Caravan and RV Battery Charger Motor Boat Battery Charger Sailing Boat Battery Charger

Share |

Multi-Language Software BC EVO

BC 9000 EVO is the most powerful and versatile battery charger in BC range, ideal for the recovery, charge, desulfation, maintenance and analysis of all 12V batteries installed on motorcycles, cars and motorhomes, as well as of caravans and boats leisure batteries. BC 9000 EVO, provided with multi-language LCD display and digital voltmeter, has the dual function of battery charger and tester of the battery and the vehicle's charging system and offers two specific charging modes: CAR MODE with a maximum charging current of 9.0 Amp and BIKE MODE with a maximum charging current of 1.0 Amp.
The charging mode selection is completely automatic, with the
innovative EASY PLUG-IN SYSTEM: to change the charging mode it is enough to disconnect and reconnect the device to the power socket. The display always shows the active charging mode.
The battery charger can be left always connected to the battery, with no risk and no need to disconnect the battery from the vehicle, keeping it fully charged during long periods of inactivity (even months).
BC 9000 EVO runs a fully automatic 8-cycles charging algorithm, to recover deeply discharged batteries (from 1.25 volts) and to recharge, desulfate and maintain all 12V batteries (traditional, gel, sealed...) from 3 to 200 Ah.
The automatic testing procedure, guided step-by-step by the instructions on the
LCD display, includes an analysis of the battery State of Charge, a battery Cranking Power test and a test of the vehicle's charging system (alternator/regulator).
BC 9000 EVO does not produce sparks and it is protected against short circuit, reverse polarity, overcharging and overheating.
The package includes a waterproof battery cable with eyelets, which can be left always installed on the vehicle, and a battery cable with insulated clamps (code 30AMPPZ). A universal 12/18 mm adapter (code ACC612V - optional) is available to recharge the battery from the cigarette lighter. The warranty is extended to 3 years.
Automatic Test Procedure:
1. Battery SOC Test at rest
2. Battery Cranking Power Test
3. Alternator/Regulator Test
Input Voltage 220÷240 Vac, 50÷60 Hz
Charging Voltage 13.8 V / 14.4 V - nominal 12 V
Charging Current 9.0 A max (CAR MODE), 1.0 A max (BIKE MODE)
Charging Algorithm 8 cycles, automatic (Initialization, Recovery,
Soft Charge, Bulk Charge, Desulfation,
Battery Analysis, Maintenance and Equalization)
Types of Batteries 12 V Lead Acid
(Traditional/Wet, Gel, MF, VRLA, AGM, Ca/Ca, etc.)
Battery Capacity - CAR MODE From 40 Ah to 200 Ah
Battery Capacity - BIKE MODE From 3 Ah to 100 Ah
Operating Temperature from -20° to +50°C
IP Class
Weatherproof - Protection against water
splash IP44. Suitable for outdoor use
Selectable Languages Italian, English, French and German (or Spanish)
(starting from December 2013)

Featuring wall mounting system
with fast dismounting



BC 9000 EVO is a digital battery charger managed by a latest-generation microprocessor, which is in charge of monitoring the battery parameters in real time and to execute a new multi-cycle charging algorithm:
1. Initialization: the device checks if one or more cells are shorted, in order to verify that the battery is in a proper condition to be recharged/recovered.
2. Recovery: if the battery is deep discharged (battery voltage starting from 1.25 V), the device tries to recover it, taking it back to a higher voltage.
3. Soft Charge: if the battery is in a condition of significant undercharge, the device provides a light pulsing current to the battery, to overcome this critical phase.
4. Bulk Charge: the device provides full current to the battery, recovering about 85-90% of the battery capacity.
5. Desulfation / Absorption: the device provides a "controlled overcharge" to recover the remaining 10-15% of the battery capacity, through the desulfation/recovery the lead-acid cells (for low or medium sulfation).
6. Battery Analysis - End Cycle Test: the device stops providing current to the battery for a short time, in order to verify whether the battery is able to retain the charge received. This test is periodically repeated during the Maintenance.
7. Maintenance: the device keeps the battery in the best charge conditions for very long periods (even months) during which your vehicle is left unused, without any possible drawback (battery overcharge, battery overheating, water and/or electrolyte loss, etc).
8. Equalization: every 30 days during long term maintenance, the device executes an equalization charge in order to balance the battery lead-acid cells, avoiding electrolyte stratification within the cells.


BC 9000 EVO features a series of 8 protections and active guard mechanisms that make it easy to install and to use, without any risks even for users without expertise:
- No interferences the vehicle's on board electronics (control unit, ABS, GPS...)
- Protection from output lines short circuit, even for an indefinite time: no sparks!
- Protection from battery polarity inversion
- Protection from battery overcharge/overheating
- Thermal protection from overtemperature
- No need to disconnect the battery from your vehicle
- Very few gas development during the charge: no need to remove the battery plugs
Laboratory Tests ensure the manufacturing of products in conformity to the regulations in force on safety and electro-magnetic compatibility. Norms and Regulations: IEC-61000-3-2(ed.3);am1;am2, IEC-61000-3-3(ed.2) CEI-CISPR14-1(ed.5);am1;am2, CEI-CISPR14-2(ed.1);am1;am2, IEC60335-1(ed.5), IEC-60335-2-29(ed.4);am1;am2.


BC 9000 EVO is specifically designed for charging and maintaining all 12V lead-acid batteries currently available on the market (traditional, VRLA, MF, AGM, GEL, Ca/Ca, etc). The device is addressed to recharge and maintain batteries with a capacity from 3 to 200 Ah (starting from 40 Ah with CAR MODE).


The package includes:
- the battery charger and tester BC 9000 EVO for long term battery maintenance, provided with a 220V power cable (2 meters long) and a battery output cable;
- a waterproof battery cable with eyelets, which can be left always installed on board;
- 30AMPPZ battery cable with clamps;
- according to the selected kit, a universal 12/18mm cigar socket adapter may be included;
- a copy of the User Manual.


You can select the display language for BC 9000 EVO between Italian, French, English and German (or Spanish). To access the Language Selection menu, please follow the following procedure:
- Keeping BC 9000 EVO disconnected from the power outlet and the battery, connect the adapter with clamps to the charger and put in contact the red clamp with the black clamp (creating a short circuit).
- Connect BC 9000 EVO to the power outlet, still holding the clamps shorted. Every time the device is disconnected and reconnected to the power supply, the language changes, according to the following sequence:
Lingua: ITALIANO -> Langue: FRANÇAIS -> Language: ENGLISH -> Sprache: DEUTSCH or Idioma: ESPAÑOL
The selected option is kept in memory for future usage.
Home  |  Company  |  Contact Us  |  Site Map  
Alessandro - Italy - 09.05.2015
Easy to use both for motorcycles and cars. I easily recharged the batteries. Great purchase.

Alex - Italy - 20.04.2015

Perfect packaging including all the components. It costs more than other products of the same category but it is really valid and easy to use, and you can even use it both for your motorcycle and your car. In half a day it brought back to life my motorcycle battery, so it confirmed that the more you pay the better!

Antonello - Italy - 07.02.2015
I bought it to maintain my motorcycle and sometimes my car, it is well-made, with a 'talking' display that explains everything and makes the manual quite unuseful. It works in an excellent way. My only criticism is that cables should be longer.