Motorbike & Motorcycle Battery Charger CAN-Bus Motorbike & Motorcycle Battery Charger Scooter & moped Battery Charger ATV & Four Wheeler Battery Charger Watercraft Battery Charger Snowmobile Battery Charger Vintage Motorcycle 6 Volt Battery Charger Vintage Car Battery Charger

Share |

BC K900 edge is the ultimate and most innovative battery charger, maintainer and reconditioner on the market, with a brand new automotive design. The device is suitable for all 6/12V batteries (traditional with liquid electrolyte and removable caps, MF, GEL, AGM, VRLA), with a specific program to recharge batteries directly through the 12V sockets installed on vehicles provided with a CAN-Bus system (like BMW motorcycles).
BC K900 edge ensures the best battery performance and a longer battery life, thanks to a full automatic 8-cycles charging algorithm, which makes it ideal for the battery analysis, recovery (starting from 1.25 Volt) and reconditioning, recharging, desulfation and long term maintenance: the device can be left always connected to the battery for an indefinite time, as long as the vehicle is unused.
With BC K900 edge, you can choose
between three different programs: for 6 Volt batteries, for 12 Volt batteries and for the direct charging through 12 Volt sockets on CAN-Bus equipped motorcycles.
The program selection is easy. 3 LEDs, one for each program, always indicate the charging mode currently active, which is held in memory for later use.
Recharging and maintaining a battery installed on a 12V-CAN-Bus-System equipped motorbike has never been so easy: the revolutionary BC KEY-LESS direct connection system allows to connect the charger directly to 12V DIN 4165 cigar sockets (installed on BMW motorcycles), without having to turn the key nor to turn on the instrument panel.
BC K900 edge delivers a maximum current of 1 Amp and is suitable for all 6/12 Volt batteries from 1.2 to 100 Ah. A couple of LEDs indicate the charging cycle executed as well as any functioning error in real time.
BC K900 edge does not produce sparks and it is protected against short circuit, reverse polarity, overcharging and overheating.
The package includes a waterproof battery cable with eyelets, which can be left always installed on the vehicle, and a battery cable with insulated clamps. A universal 12/18 mm adapter (optional) is available to recharge the battery from the cigarette lighter. The warranty is extended to 3 years.
Input Voltage 220÷240 Vac, 50÷60 Hz
Charging Voltage 6.9 V / 7.2 V - nominal 6 V (6 Volt mode)
13.8 V / 14.4 V - nominal 12 V (12 Volt mode)
Charging Current 1 A max
Charging Algorithm 8 cycles, automatic (Initialization, Recovery,
Soft Charge, Bulk Charge, Desulfation,
Battery Analysis, Maintenance and Equalization)
Types of Batteries 6/12 V Lead Acid
(Traditional/Wet, Gel, MF, VRLA, AGM, Ca/Ca, etc.)
Battery Capacity From 1.2 Ah to 100 Ah
Operating Temperature from -20° to +50°C
IP Class
Weatherproof - Protection against water
splash IP44. Suitable for outdoor use

Featuring wall mounting system
with fast dismounting



1. Charging Program Selection
Once you connected the battery charger to the power outlet, a LED will show you the active charging mode (6V, 12V or 12V CAN-BUS). To change the charging mode, please follow this procedure:
1. With the device disconnected from the battery and from the power outlet, connect the clamps to the device and put the red and the black clamps together (creating a permanent short circuit).
2. Connect the device to the power outlet. The active charging mode will change and it will be displayed by the correspondent LED (6V, 12V or 12V CAN-BUS).
3. Disconnect the device from the power outlet and separate the clamps. The selected charging mode will be kept in memory until you repeat this procedure.
2. Recharging, Reconditioning and Mantenance - 100% automatic and complete
Once the right charging program for your battery is selected, just connect BC K900 edge to the battery to make the 8-steps full-automatic charging procedure start. BC K900 edge brings your battery to the maintenance phase, recovering it gently if necessary, giving it energy and power during the charging and desulfation steps and keeping it constantly under control, from the initial test to the end-cycle battery analysis.


BC K900 edge is managed by a latest-generation microprocessor, which is in charge of monitoring the battery parameters in real time and to execute a new multi-cycle charging algorithm:
1. Initialization: the device checks if one or more cells are shorted, in order to verify that the battery is in a proper condition to be recharged/recovered.
2. Recovery: if the battery is deep discharged (battery voltage starting from 1.25 V), the device tries to recover it, taking it back to a higher voltage.
3. Soft Charge: if the battery is in a condition of significant undercharge, the device provides a light pulsing current to the battery, to overcome this critical phase.
4. Bulk Charge: the device provides full current to the battery, recovering about 85-90% of the battery capacity.
5. Desulfation / Absorption: the device provides a "controlled overcharge" to recover the remaining 10-15% of the battery capacity, through the desulfation/recovery the lead-acid cells (for low or medium sulfation).
6. Battery Analysis - End Cycle Test: the device stops providing current to the battery for a short time, in order to verify whether the battery is able to retain the charge received. This test is periodically repeated during the Maintenance.
7. Maintenance: the device keeps the battery in the best charge conditions for very long periods (even months) during which your vehicle is left unused, without any possible drawback (battery overcharge, battery overheating, water and/or electrolyte loss, etc).
8. Equalization: every 30 days during long term maintenance, the device executes an equalization charge in order to balance the battery lead-acid cells, avoiding electrolyte stratification within the cells.


BC K900 edge features a series of 8 protections and active guard mechanisms that make it easy to install and to use, without any risks even for users without expertise:
- No interferences the vehicle's on board electronics (control unit, ABS, GPS...)
- Protection from output lines short circuit, even for an indefinite time: no sparks!
- Protection from battery polarity inversion
- Protection from battery overcharge/overheating
- Thermal protection from overtemperature
- No need to disconnect the battery from your vehicle
- Very few gas development during the charge: no need to remove the battery plugs
Laboratory Tests ensure the manufacturing of products in conformity to the regulations in force on safety and electro-magnetic compatibility. Norms and Regulations: IEC-61000-3-2(ed.3);am1;am2, IEC-61000-3-3(ed.2) CEI-CISPR14-1(ed.5);am1;am2, CEI-CISPR14-2(ed.1);am1;am2, IEC60335-1(ed.5), IEC-60335-2-29(ed.4);am1;am2.


BC K900 edge is specifically designed for charging and maintaining all 6/12V lead-acid batteries currently available on the market (traditional, VRLA, MF, AGM, GEL, Ca/Ca, etc). BC K900 edge is addressed to recharge and maintain batteries with a capacity from 1.2 to 100 Ah.


The package includes:
- the battery charger and maintainer BC K900 for long term battery maintenance, provided with a power cable (2 meters long) and a battery output cable;
- STD2V waterproof battery cable with eyelets, which can be left always installed on board;
- 30AMPPZ battery cable with clamps;
- universal cigar socket adapter 18 mm / 12 mm (DIN 4165 - BMW);
- copy of the User Manual.
Home  |  Company  |  Contact Us  |  Site Map  
Davide - Italy - 04.03.2015
The battery of my bmw f800gs was dead... now it's perfect, the product is okay in my opinion! I recommend it to everybody, it's practical and convenient.

Enrico - Italy - 17.04.2015
The product corresponds to the technical features indicated on the website. Great reliability, excellent. It is worth the purchase though its cost.

Stefano - Italy - 13.04.2015
Extremely satisfied
It perfectly corresponds to its description. I used it to maintain my BMW motorcycle through CAN-Bus and it worked perfectly.

Emanuele - Italy - 05.03.2015
As described
The instructions were clear and easy.
I use it on my BMW GS 1200 2014 with CAN Bus adapter. I also recharge my lawnmower with further connection kits.

Franco - Italy - 02.03.2015
Great purchase
Perfect for my BMW r1200gs Adv. Very easy to use: put it under power, select CANBUS and insert the socket under the seat. The cable equipment is perfect: cables are very easy to mount and dismount. No heating even in the charging step. In brief, great purchase.

Alberto - Italy - 30.06.2014

The product has fully satisfied us for the following reasons:
Very easy to use
Complete of various connecting cables that reflect our needs
Made in Italy

Michael - Germany - 13.06.2014
Absolutely the top!
You set the charger on Can-bus and the charging procedure starts. Connected to the socket of my BMW F 800 GT it works flawlessly. I find this charger very advisable.

Carlos - Spain - 12.05.2014

Perfect Can Bus (BMW R 1100 RT). You connect it to the socket and it is ready! It maintains the battery automatically. Very easy to use.